DIRECTIONS FOR USE:

APPLICATION INSTRUCTIONS

Apply BRASH at the specified rates and growth stages in the Annual Weeds and the Biennial and Perennial Weeds rate tables unless instructed differently in the Food/Feed Crop Specific Information or Non-Food/Feed Use-Specific Information sections in the label. Make applications of BRASH to actively growing weeds using aerial, broadcast, band, or spot spray applications. BRASH may be applied using water or sprayable fluid fertilizer as a carrier. For preplant or pre-emergence uses, sprayable fluid fertilizer may be used as the carrier for all crops listed on this label. Postemergence applications with sprayable fluid fertilizer may be made on pasture, hayland, or wheat crops only.

The most effective application rate and timing varies based on the target weed species. In mixed weed populations, the correct rate is determined by the weed species requiring the highest rate. Inadequate control may be observed if application is delayed since weeds may exceed the maximum size stated on this label.

IRRIGATION: In irrigated areas, it may be necessary to irrigate before application of BRASH to ensure active weed growth.

SPRAY COVERAGE: Ensure weeds are thoroughly covered with spray. Dense leaf canopies may shield smaller weeds and prevent adequate coverage.

AERIAL APPLICATION METHODS AND EQUIPMENT

Water Volume: Use 3-10 gallons of water per acre. Use the higher spray volume when treating dense or tall vegetation.

GROUND APPLICATION (BANDING)

When applying BRASH by banding, determine the amount of herbicide and water volume needed using the following formula:

• Band width in inches/Row width in inches x Broadcast rate per acre = Banding Herbicide rate per acre.
• Band width in inches/Row width in inches x Broadcast volume per acre = Banding water volume per acre.

GROUND APPLICATION (BROADCAST)

For optimal performance, use 5-40 gallons of spray solution per broadcast acre. Use the higher spray volume when treating dense or tall vegetation.

SPOT OR SMALL AREA APPLICATION

BRASH may be applied to individual clumps or small areas (SPOT TREATMENT) of undesirable vegetation using handgun or similar types of application equipment. Apply diluted sprays to allow complete wetting (up to runoff) of foliage and stems. For knapsack or other small capacity sprayers, utilize the table below to calculate material needed. (The table below is based on the assumption that the spot treatment rate equates to 60 gallons per acre on the broadcast basis.)

RESTRICTIONS AND LIMITATIONS:

• Maximum single application rate: 1 gallon per acre with no more than 2 applications per year.
• Preharvest Interval (PHI): Refer to the Food/Feed Crop-Specific Information section of this label.
• Crop Rotational Restrictions: The interval between application and planting rotational crop is provided below. Always exclude counting days when the ground is frozen. Planting at intervals less than specified below may result in crop injury. Moisture is essential for the degradation of this herbicide in soil. If dry weather prevails, use cultivation to allow herbicide contact with moist soil.
  • Planting/replanting restrictions for BRASH applications of 5.66 pints per acre or less: No rotational cropping restrictions apply at 120 days or more following application. Additionally, for annual crop uses in this label including sorghum, follow the preplant use directions in the Food/Feed Crop-Specific Information section of this label. For barley, oat, wheat, and other grass seedlings, the interval between application and planting is 10 days per pint per acre.
  • Plantini'replanting restrictions for application of more than 6 pints and up to 8 pints of BRASH per acre: Corn, sorghum, cotton (east of the Rocky Mountains) and all other crops grown in areas with 30" or more of annual rainfall may be planted 120 days or more after application. Barley, oat, wheat, and other grass seedlings, may be planted if the interval from application to planting is 10 days per pint per acre east of the Mississippi River and 15 days per pint per acre west of the Mississippi River. For all other crops in areas with less than 30" of annual rainfall, the interval between application and planting is 180 days or more.
• Rainfast period: The effectiveness of BRASH may be reduced if rainfall or irrigation occurs within 4 hours after postemergence applications.
• Stress: Unsatisfactory control may result if BRASH is applied to crops under stress such as stress due to lack of moisture, hail damage, flooding, herbicide injury, mechanical injury, or widely fluctuating temperatures.
• Do not apply to crops that exhibit injury (leaf phytotoxicity or plant stunting) produced by any other prior herbicide applications, because this injury may be enhanced or prolonged by applying BRASH.
• Do not apply through any type of irrigation equipment. Do not contaminate irrigation ditches or water used for domestic purposes.
• This product cannot be used to formulate or reformulate any other pesticide product.

WEEDS CONTROLLED:

ANNUAL WEEDS:

Beebalm, Broomweed, Buckwheat, Buffalobur, Burdock, Buttercup, Chickweed, Cockle, Cocklebur, Coreopsis, Croton, Devilsclaw, Doqfennel, Evening Primrose, Falseflax, Fleabane, Flixweed, Henbit, Knotweed, Kochia, Lambsquarters, Mallow, Morningglory, Pennycress, Pepperweed, Pigweed, Poorjoe, Purslane, Ragweed, Sedge, Shepherdspurse, Smartweed, Sneezeweed, Sowthistle, Sunflower, Thistle, Velvetleaf.

BIENNIAL and PERENNIAL WEEDS:

Bindweed, Bittercress, Buckeye, Bullnettle, Chicory, Clover, Dandelion, Dewberry, Curly Dock, Elderberry, Goldenrod, Goldenweed, Groundsel, Honeysuckle, Horsenettle, Poison Ivy, Knapweed, Marshelder, Mesquite, Milkweed, Nightshade, Persimmon, Prickly Lettuce, Rabbitbrush, Ragwort, Redvine, Sagebrush, Smartweed, Red Sorrel, Sowthistle, Spurge, Tallow Tree, Thistle, Vetch, Yankeeweed, Yellow Starthistle.